in this video we'll be replacing
the interior light bulbs in this 2021 Toyota Tacoma with all new
LED bulbs from Ayla lighting for this installation you'll
need a trim tool and some tape insert your trim tool on the edge closest
to you nearest the switch pry it down until the clip is free on the opposite
side use your tool to pry out that clip pull down the lens and slide it
towards the switch to remove it we highlight here the three Clips holding it in
wrap some tape around the bulb to make it easier to pull out pull out the incandescent
bulb replace it with the LED [Music] and test it [Music] put the
outside edge of the lens in first then push up the other Corners to lock it now repeat those steps on the other side
pry out both edges closest to the switch wiggle it out towards the middle [Music] wrap the bulb and tape and pull it out replace it with the LED foreign [Music] put in the outside edge of the lens first
[Music] and then push in the other corners these new LED bulbs light up the entire
cabinet of the truck and our Pure 6000k White for this insulation you'll
need a flathead screwdriver Begin by flipping down visor there's a small
slot on the edge closest to you insert your screwdriver into the slot and push the
Locking clip in while pushing in pry The Edge out and pull out the lens [Music] use
your screwdriver to pry out the festoon bulb replace with the LED [Music] and rotate the bulb until the chips face out test it and we can replace the lens [Music]
push the top tabs of the lens in first then push in the bottom you may have to use your
screwdriver to push in the tab before closing now repeat those steps for the other light insert your
screwdriver into the slot and push the Locking clip in while pushing in pry out the edge and pull
out the lens use your screwdriver to pry out the festoon bulb replace with the LED and rotate
until the bulb chips face out foreign [Music] and we can replace the lens push the top tabs
of the lens in first then push in the bottom the new LED vanity mirror lights do a great job
lighting up the entire cabin in this truck [Music] for this installation you'll
need a flathead screwdriver the dome light has four tabs in the lens that
hold it in on the front side of the lens there are two small slots insert your screwdriver
into the slots and pry the lens down slide the lens forward to free the back tabs rotate
the incandescent bulb until the tip is vertical you could use your screwdriver
to pry out the bulb [Music] install the LED into the side with a hole [Music] push in the other side and rotate
the bulb so the chips are facing down test it and we can replace the lens we
highlight here where the tabs on the lens fit into the housing put the rear tabs
in first then push up the lens to lock it the new LED bulbs light up
the entire cabin of the truck and our Pure 6000k White [Music]
