

This post may contain affiliate links which means I may receive a commission for purchases made through links. Learn more on my Private Policy page.
Price Magnetic Strips for Tools on Amazon: http://amzn.to/2m4aRt1 Lathe Tool Setup – Having a good solid lathe setup and …
As a professional copywriter, let me present to you a closer look at Andy’s woodturning setup. Andy, from glassesworkshopaddict.com, talks about his lathe position, accessories and the thought process behind it.
Andy’s lathe is located in the front corner of his workshop, the most populated area where he works at his bench. It’s not a traditional location since he would have more tool storage, cabinets and other things he uses every day at the workbench, but he chose this location because he has a dust collection drop on the floor sweep. It makes cleaning up easy since large dust and chips that come off the lathe go on the floor, which he can sweep up into the dust sweep that goes through the dust collection into the cyclone drop into the barrel.
Underneath the lathe, Andy has a temporary cabinet that he borrowed from his last shop. He plans to build a dedicated full-length or full-width cabinet that allows for more knee and leg clearance, making it more comfortable for him to turn and use the lathe.
Behind the lathe, he has all his woodturning tools and accessories, chucks and things like that. Since he is not allowed to put anything on the back walls of his shop, he anchored the tool rack with two large bolts in some super struts that are connected to the framing of the building. Andy’s traditional tools are on magnetic holders which have three rows to get enough magnetic suction. Gouges with a radius don’t have a lot of contact surface for the magnets, which require a lot of magnetic force to hold them in place.
Above, in the top-left, Andy has a secondary Chuck with some permanent cold jaws and various size Chuck jaws for different sized turnings, smaller ones in the bins, Chuck adapters and Allen keys for the lathe and the Chucks themselves. On the top right, he has the carbide insert tools, the large size that Rockler offers, including round, diamond radius, square and traditional square. Andy also has two other sizes, many and pen turning kits which are in the cabinet below the carbide tools. Andy built these tools storage-wise, similar to the traditional lathe storage that you see all over the internet, which is very comfortable with a lot of room for your hand to grab and less cumbersome.
To the right of the carbide tools, Andy has the 6-inch faceplate that comes with the lathe and put it on a large finishing nail attached to three magnets superglued to the board. It keeps the Chuck in place, preventing it from flopping around if he takes things on and off the board. Above that, he has a couple of rolls of sandpaper strips for sanding at the lathe.
Below the faceplate, Andy has his live screws, spur drive, keyless Chuck for the tailstock, Forstner bit for drilling out some material, and a custom turned handle with an Allen key.
Below that, he has three calipers for use during turning for interior and exterior, OD and ID for when turning. That’s a quick little brief overview of Andy’s turning center here with his Nova galaxy DVR lathe from his workshop, glassesworkshopaddict.com.
In conclusion, Andy’s setup is quite impressive, very organized and allows for a convenient and efficient workspace. Anyone who’s involved in woodturning will appreciate and be inspired by Andy’s setup.
This post may contain affiliate links which means I may receive a commission for purchases made through links. Learn more on my Private Policy page.
[ad_2]
Source link