in this video we’ll be replacing
the interior lights in this 2019 Honda Passport with all new
LED bulbs from Ayla lighting for this installation you’ll need a trim tool start by pushing in the on
and off button on the light hold it in and use your trim tool to pry out
the end to remove the clips holding it in here we highlight the clips and how they hold
the lens in pull out the incandescent bulb install the LED bulb and test it replace the lens line up the clips and push
the lens in and then repeat those steps on the other side pushing the on and off button and
hold it use your trim tool to pry free the edge pull out the incandescent bulb replace with the LED bulb and then test it replace the lens line up the clips and
then push it in until it clicks in place for this installation you’ll
need a flathead screwdriver Begin by flipping down the
visor and flip up the vanity foreign there’s a small Gap at the bottom of the
light use your screwdriver to gently pry it free pull it down to remove the top tabs now use your screwdriver to
pry out the incandescent bulb install the LED and rotate it so the LED chips face
out Slide the top of the lens in first then push in the bottom now repeat
those steps for the other side pry out the bottom of the lens and pull
it down pry out the incandescent bulb and replace it with the LED Slide
the top of the lens in first then push in the bottom the new LED bulbs are a
huge upgrade from the incandescent bulbs foreign Begin by opening the center console in the front of the console you’ll see the light
housing you can use your fingers to pull it out now turn the socket counterclockwise to unlock it pull out the incandescent bulb and replace
it with the LED bulb test it and we can put it back together line up the tabs on
the socket with the slots in the housing install the socket and turn
it clockwise to lock it push the housing back in and
your installation is complete for this installation you’ll need a trim tool start by pushing in the outside of the light use your trim tool to pry out the end then slide
it to remove the clips holding it in foreign use some tape and wrap it
around the incandescent bulb pull on the tape to remove
the bulb install the LED bulbs and then repeat those steps for the other
side push in the outside of the lens and then use your trim tools to pry The Edge free
foreign tape around the incandescent bulb and pull it out replace it with the LED bulb and then test it replace the lens slide in the outside first
and then push it in until it clicks in place and then do that for the other lens for this installation you’ll need a
trim tool Begin by opening the tailgate there are four Clips holding the lens in use
your trim tool to gently pry out the lens here we highlight how and where
the clips hold it in place remove the incandescent bulb replace it with the LED and then test it pushing the front of the lens
and then push up the other side to lock it in place and a huge upgrade from the incandescent
bulb to light up the entire rear of this passport the new interior LED bulbs are great and
a huge upgrade from the incandescent bulbs
